Blog

A furnace is not ready for production simply because its burners light or its control screen displays the setpoint. Commissioning must establish that utilities, mechanical systems, controls and safety interlocks work as intended. Performance acceptance must then show, under agreed operating conditions, that the furnace meets its contractual commitments for output, energy consumption, emissions and […]

Furnace controls are easy to overlook when production is running. Yet an obsolete PLC, undocumented code or unsupported HMI can turn a minor fault into an extended shutdown, and leave operators without reliable information on energy use, temperature performance or downtime causes. In 2026, automation modernization is a practical way to reduce that exposure and […]

Morning Edition | 17 October 2026 Protective atmosphere control is not an accessory to a heat-treatment recipe. It is part of the process itself. A furnace can reach its temperature setpoint and hold it accurately, yet still deliver poor surface quality if oxygen, moisture or carbon activity are not controlled around the load. For manufacturers, […]

Induction heating is increasingly valuable in steel rolling mills not as a blanket replacement for every reheat furnace, but as a precise way to add heat where and when the process needs it. For billet, bloom and bar lines, an inline induction heater can raise or equalise temperature immediately before rolling: reducing unnecessary reheating, limiting […]

A reheat furnace is not just a source of heat: it is a production constraint, a fuel-cost driver and a determinant of rolling consistency. For a steel rolling mill, the choice between pusher-type and walking beam design affects billet handling, temperature uniformity, scale formation, maintenance and the ability to respond to product changes. Neither design […]

Refractory linings are engineered components, not interchangeable consumables. Their performance affects heat loss, product quality, maintenance frequency, worker safety and the cost of unplanned downtime. For a steel rolling mill, heat treatment line or melting operation, the right choice depends on what each zone experiences: temperature, cycling, abrasion, atmosphere and chemical contact. In this 2026 […]